Keller PYRO CellaTemp PA, Руководство пользователя, Страница: 8 / 12

Operating manual
4
6 Setting parameters at the pyrometer
6.1 Setting the parameters using the button
Use the buttons
▲▼ and the „MODE" button on the rear panel to ac-
cess and configure parameters. With these buttons you can view and
adjust all settings required for pyrometer operation.
Menu structure:
1. Press the MODE button while in normal operating mode to switch
to "configuration layer" mode Die Codeseite des gewünschten Pa-
rameters mit
▲▼
auswählen.
2. Use
▲▼
to select the configuration layer for the parameter you
wish to set.
3. Press MODE to confirm. Press
▲▼
to select the particular pa-
rameter.
4. Press MODE to confirm. Press
▲▼
to adjust the parameter val-
ue.
5. Press MODE again to end. Press
▲▼ to select END/SAVE
6. Now use MODE to either apply the changes you have made to
the settings [
SAVE
] or to close without saving these changes
[
END
]. After that, the display panel will resume showing the tem-
perature reading.
6.2 Operation of the pyrometer via terminal program
By default, the pyrometer has fully integrated communications software
to the point-to-point connection with a PC. As an alternative to the
CellaView software, all parameters that are required for a measurement
data acquisition or a general configuration of the pyrometer can be con-
figured via a simple terminal connection using the terminal program.
Most key parameters are directly available in the main menu. Further
functions are contained in submenus. Navigation within the menus is ex-
plained in the following graphics:
Normal
operating mode
(temperature)
Select
config. layer
C000-
C999
Select
parameter
EPS
Adjust
parameter
99.9
MODE
MODE
MODE
▲▼ ▲▼
▲▼