02
Operating instructions
smart slider - Operating instructions
02. Electric operation
2.4 If mode: AUTOMATIC operation
2.5 Disengaging the Lock
The whole movement is controlled via an “automatic control”, which means that when the user presses the
operating button, the automation will fully open or close the sliding assembly automatically. The user remains
responsible for the sliding whole in it keep an eye out, make sure that no one is in the danger zone.
TO OPEN
Give an open command via the control button, the sliding part will open fully automatically.
The system stops automatically when fully open.
TO CLOSE
Give a close command via the control button, the sliding part will full close automatically.
The system stops automatically when fully closed.
ALWAYS TAKE CARE, BEFORE AND WHEN OPERATING THE SLIDING UNIT, THAT THE ENTIRE
SLIDING ZONE IS FREE OF OBSTACLES AND/OR PERSONS AND THIS DURING THE ENTIRE RUN
PERIOD.
In the event of a power failure or a defect in the drive, and the window is closed, and you want to open it, you can
disengage the lock mechanism.
This allows you to manually open your sliding system by hand. First check whether your sliding assembly itself has
no defects !!
IF YOU MOVE THE SLIDING SYSTEM BY HAND, MAKE SURE THE MOVEMENT IS CONTROLLED. IF
NOT, THERE MAY BE DAMAGE TO THE SLIDING SYSTEM AND/OR TO THE WINDOW.
Disengage the automatic lock
Use the supplied hex socket wrench M5, locate the hex socket
bolt at the top of the motor u-housing in the running area
between the brushes.
Insert the key in it and turn it clockwise, until you feel resistance.
The lock is disengaged.
You can open the window manually.
If you close the window the lock still will be open.
If you want that the sliding system locks automatically again,
you must turn the same bolt counter wise until you feel again
resistance.
6
Keller minimal windows
®
|
997-00220
| 05-2022
Keller minimal windows
®