Keithley KPCI-PDISO8A, Руководство пользователя

Страница: 47 / 72

5-12 Troubleshooting KPCI-PIO32IOA and KPCI-PDISO8A User’s Manual
3. Again determine the PCI resources detected by your computer after the KPCI-PIO32IOA
and KPCI-PDISO8A board is installed. Windows Plug and Play should find and configure
the new board as a PCI resource if all of the following are true:
•
The board functions properly as a PCI device.
•
The contacts of the expansion slot in which the OK board is installed are in good
condition.
•
The OK board is seated properly in the expansion slot.
Do the following, as you did in step 1:
a. Insert an unbootable diskette.
b. Turn ON the computer and allow the boot cycle to stall at the
Non-system disk or disk
error…
message.
c. Again, note the displayed list of PCI devices. A new device should be listed, likely as an
unidentified peripheral. If your resource listing includes PCI slot numbers, the slot num-
ber for the new device should match the number of the slot in which your board is
installed.
d. Remove the diskette and allow the boot cycle to finish.
I/O test
WARNING To avoid a possible shock hazard, always turn OFF your computer
and any external circuits connected to the KPCI-PIO32IOA or
KPCI-PDISO8A board before removing or replacing the board.
CAUTION The tests outlined in this subsection involve handling of the
KPCI-PIO32IOA or KPCI-PDISO8A circuit board. Handle the
board at the mounting bracket using a grounded wrist strap. Do not
touch the circuit traces or connector contacts. If you do not have a
grounded wrist strap, periodically discharge static electricity by
placing one hand firmly on a grounded metal portion of the com-
puter chassis.
Always reinstall the cover before turning the computer ON.
Channel assignments
Table 5-2 summarizes DriverLINX logical channel assignments.
Table 5-2
DriverLINX board channel assignments
Model
DriverLINX
Channel I/O
KPCI-PDISO8A 0
1 Inputs (IP0-IP7)
Outputs (OP0-OP7) with readback
KPCI-PIO32IOA 0
1
2
3 Inputs (IP0-IP7)
Inputs (IP8-IP15)
Outputs (OP0-OP7) with readback
Outputs (OP8-OP15) with readback