Section 2: Installation and connections
Model 3762 10-Channel High Voltage Multiplexer Card User's Manual
2-2
3762-900-01 Rev. A / July 2017
Card connectors
All connections will need to be made before the card is installed in the mainframe. Because the card
is rated at higher voltage than the mainframe, no backplane connectors are provided internal to the
card. Ensure that any signals connected to the multimeter or mainframe are limited to the allowable
ratings of the device. For more information about wire connections, see
Wire selection and
preparation
(on page 3-2).
Figure 2: 3762 screw terminal connectors
Card installation
Slot covers must be installed on unused slots to prevent personal contact with high voltage
circuits. Failure to recognize and observe standard safety precautions could result in
personal injury or death due to electric shock.
