INSTALLATION / OPERATION & PARTS CATALOG
CleenSweep
®
Hydraulic - CSH
25
DOC03668 Rev. G
A.
With the tarp laying down on the floor of the trailer, center the 2” [50 mm] pipe in the top pocket of the
tarp which has the notch cut out in the center. On the top side of the pipe drill (4) holes through the
tarp and pipe and install rivets (not supplied) to hold the pipe in place.
B.
Center the UHMW strips in the lower pockets of the tarp. Drill (4) holes completely through the tarp
and UHMW strips. Use bolts with washers and nylock nuts (not supplied) or use rivets with washers
(not supplied) to keep the UHMW strips in place. Bolts or Rivets should be installed from the bottom
so nothing sharp scrapes or catches on the floor.
3. Find the center of the top pipe when the tarp is in the hanging position. Drill (2) 3/8” [9.5 mm] holes,
evenly spaced, through the top pipe to attach the U-bolt. It must be centered and installed so that when
the tarp is hanging from the winch, the threads of the U-bolt are facing downward. If necessary, you can
make the notch in the tarp wider in the middle to accommodate the U-bolt.
4. Lay the tarp in the rear of the trailer, with the handles on top of the tarp and the 2” [50 mm] top pipe
resting inside of the trailer about 12”-24” [305-610 mm] (depending on type of material being unloaded)
making sure it is not past the ends of the slats when they are retracted to the front. This will be where
the tarp stops during unloading with the rest of the tarp hanging off the back of the trailer.
5. Release the winch strap brake and thread the strap through the strap guide on the winch, through the
slot in the front shield (if winch is low-mounted) and through the strap roller. Pull the strap to the end of
the trailer, making sure that the strap is not twisted.
6. Wrap the strap loosely around the top pipe 3 times, pull tight and tighten the U-bolt to hold the strap
securely in place.
Max strap
extension
set using
stop bolt
U-Bolt
Align centerline of tarp
with centerline of top pipe
Drill (2) 3/8” [9.5 mm]
holes through the top pipe
for mounting the U-bolt
Wrap the end of the strap
around the top pipe (3x)
and secure it to the pipe
using the U-bolt assembly.