C le anup
Asse mble tip and guard
Spray
1. Do Pressure Relief, steps 1 - 4(page 5). Remove
siphon tube set from paint and place in flushing fluid.
NOTE: Use water for water base paint and mineral
spirits for oil base paint.
6. Raise siphon tube above flushing fluid and run
sprayer for 15 to 30 seconds to drain fluid.
Relief pressure, page 5.
Insert tip gasket and seal kit.
Spray test pattern. Adjust pressure to elimin -
ate heavy edges. Use smaller tip size if pres-
sure adjustment can not eliminate heavy edges. 2. Turn p ower ON. Turn prime valve horizontal.
7. Close drain valve. Trigger gun into flushing pail
to purge fluid from hose. Turn power OFF.
8. Open prime valve.Unplug sprayer.
Insert Switch tip.
Hold gun perpendicular, 10 -12in. from surface.
Spray back and forth. Overlap by 50%. Trigger
gun after moving and release before stopping.
3. Increase pressure to 1/2.Hold gun against paint pail.
Take trigger safety OFF.Trigger gun until flushing
fluid appears
9. Remove filters from gun and sprayer, if installed.
Clean and inspect. Install filters.
C le ar C log
Screw assembly onto gun. Tighten.
Release trigger, put safety ON. Rotate Swi-
tchTip. Take safety OFF. Trigger gun to
clear clog. Never point gun at yo ur hand or
into a rag!
4. Move gun to wastepail, hold gun against pail, trigger
gun to thoroughly flush system.Release trigger and
put trigger safety ON.
10. If flushing with water, flush again with mineral
spirits, or Pump Armor, to leave a protective
coating to prevent freezing or corrosion.
Put safety ON. Return SwitchTip to original
position. Take safety OFF and continue
spraying.
5. Turn prime valve down and allow flushing fluid to
circulate for 15 seconds to clean drain tube.
11. Wipe sprayer, hose and gun with a rag soaked
in water or mineral spirits.
