Keiser KMS800, Руководство по эксплуатации

Страница: 4 / 7

4
5
Operation
Check that the power supply shown on the rating plate is the same as the mains power supply.
Always hold the machine with both hands. Press the starting lockout button (1).
Press the ON/OFF switch (2).
For safety reasons, the ON/OFF switch cannot be locked! Always work with the ON/ OFF switch
fully pressed.
To stop working, release the ON/OFF switch.
Machines with 2-speed gear units have two maximum speeds available (First gear: Slow and
Second gear: Fast).
To change from one gear to the other, turn the gear selection lever. Only ever actuate it when
the machine is at a standstill.
Always reduce the speed when submerging the mixing tool in the mixing material or lifting it
out. Once the mixing tool is fully submerged, increase the speed again to ensure that the
motor is adequately cooled.
During mixing you should guide the machine around the mixing container. Continue mixing
until all of the mixing material is completely mixed. Please follow the processing instructions
of the manufacturer of the material.
The greater the viscosity of the material, the greater the impact of the torque forces on the
machine, so you should be prepared for this when you carry out your work.
If the mixing tool comes into contact with a surface (e.g. the bottom of the tub) while running,
it may kick back.
Set the machine down resting on the guard handle after you have finished your mixing work.
Proper use
The machine is designed for mixing liquid and powder-based building products such as
paints, mortar, adhesives, plaster and similar substances. Use the right mixing tool for the
consistency of the material and the quantity to be mixed.
Please refer to the information in the technical data when choosing the size of mixing tool
(diameter/ mixing action). If the wrong mixing action or mixing tool diameter is selected,
this may cause the machine/gear unit to become overloaded and lead to damage as a result.
Please remember that a mixing tool with a mixing action from the top down puts a greater
strain on the electrical tool than one with the reverse mixing action.
This electrical tool is not designed for use in continuous operation.
Given the high torque levels generated by the machine, it must not be used as a power drill.
The machine must not be used for the preparation of foodstuffs.
The machine is not suitable for mixing materials containing graphite dust, brine or slurry.
Mixing of these materials or substances may damage the machine beyond repair.
Assembly Operation
Always pull the power plug out of the socket outlet before carrying out any work on the
machine.
Fitting the mixing tool / tool change-over: Screw the mixing tool with a size M14 male
thread into the M14 adapter on the mixing shaft. The mixing tool tightens itself during
operation.
To release the mixing tool you will need one SW 22 and one SW 24 open-ended wrench.
Place the one open-ended wrench on the adapter and the other on the hexagonal holding
fixture and turn them both in opposite directions to one another until the mixing tool is
released