KegLand KL25959, Быстрый старт

Страница: 5 / 9

KL25164 - Cannular Fully Automatic - Single Lane
Page
5
of
9 www.KegLand.com.au Last Updated 25/05/2023 14:27 PM
Common Faults and Troubleshooting
Fault Possible Cause Solution
No water in water pump Loose or damaged seal Inspect the seal and tighten /
replace
Leaking Keg during washing /
filling Cylinder Loose Inspect cylinder pressure
Keg not seated correctly Fix keg position
Poor seal on keg spear Adjust seal ring
Power Failure Voltage exceeds the working
limit of PLC Inspect input Power
Short circuit Inspect Circuit
Indicator Lamp not working Lamp is damaged Replace Lamp
Residual beer in keg after
washing Washing time is too short Adjust time on PLC
Extractor tube damaged Inspect tube for damage and
replace if required
Low Filling Speed Retain-Valve pressure is too
high Adjust pressure
Cannot Fill Beer source pressure is too
low Adjust pressure
PLC Time Parameter Adjustments
Follow the steps below to adjust any of the time parameters.
Below is the keg washing process page