KL25164 -
Cannular Fully Automatic - Single Lane
Page
4
of
9
Last Updated 25/05/2023 14:27 PM
(0 means little oil and 9 mean enough oil. No show between 0 and 9)
Adjustment of Pneumatic Cylinder Actuation Speed
The actuation of the pneumatics can be controlled by adjusting the needle valves on the pneumatic
arms.
•
Reduce raising speed; adjust upper needle valve clockwise.
•
Reduce falling speed; adjust lower needle valve clockwise.
Ensure that you tighten the lock nut on the needle valve after making any adjustments.
Each pneumatic cylinder can be manually actuated allowing you to inspect the raising/lowering
speed by pressing the corresponding red button on the five-way air manifold.
Operation and General Maintenance
Operation Procedure
1.
Fill the hot water tank with clean water by opening up your water valve leading into this
tank. Filling of the hot water tank will automatically shut off once the float valve has reached
its raise position. Water will be automatically replenished into the hot water tank as
required.
2.
Open the inlet of the caustic tank and close it when the level reaches 15
–
20mm to the
caustic tank. Dispense the caustic for use.
3.
Invert the keg and place onto the washing head
4.
Perform a final check before starting the keg washing procedure to ensure all pressures and
settings are correct.
Maintenance
1.
Turn off power, air source and beer source after finishing washing/filling run and clean the
operating platform
2.
Clean the sanitiser tank and fill the sanitiser tank before operating. Change the sanitiser
periodically
3.
Clean the filter periodically
4.
Ensure the water trap is emptied periodically and the lubricator is filled with lubricant.
If you will be shutting down the machine for a long period of time or the ambient temperature is
expected to drop below 0C; drain off all the water in the water pump and pipeline system to prevent
any water freezing or damaging the internals of the pump/pipes.
