Bucket Blaster Instruction Manual
Page
3
of
10
Last Updated 9/09/2020 2:10 PM
Items Included
1 x 15L Bucket
1 x Stainless Steel Stand
1 x Submersible Pump
1 x Spray Wand and Jet Nozzle
1 x ½ inch female tee piece
1 x
9.5mm x ½ inch male duotight fitting
grey gas ball lock disconnect with MFL
black liquid ball lock disconnect with
1 x 9.5mm EVABarrier Tubing
Assembly
1.
Break the seal on the lid and remove the lid from the bucket. Confirm you have all
the included items.
2.
Secure the pump to the plate of the stand.
3.
Screw the ½ inch female tee piece on to the ½ inch male thread on the pump.
4.
Screw the spray wand and jet nozzle in to the vertical female thread of the ½ inch
tee piece.
5.
Screw the 9.5mm x ½ inch duotight fitting in to the ½ inch tee piece
6.
Cut the beer line into three equal lengths, ensuring the ends are cut straight and
cleanly. It is suggest that a tube cutter is used to cut this beer line.
7.
Screw the 9.5mm x FFL duotight fittings on the grey and black ball lock disconnects.
8.
Push separate lengths of beer line into the 9.5mm x ½ inch duotight fitting, and the
duotight fittings on each of the ball lock disconnects.
9.
Push each of the lengths of the beer line into the 9.5 mm duotight tee piece as
shown below.
