BrewZilla 35L - Gen 4 Instruction Manual
Page
2
of
31
Last Updated 22/03/2022 16:53 PM
WARNING IMPORTANT INFORMATION!
1.
Please read this ENTIRE instruction sheet before using the BrewZilla unit. If you are
unsure about any part of using this brewery, please refer to the YouTube videos that
we have made or contact your local distributor.
2.
If the BrewZilla is damaged in any way do not use it. Contact your local distributor.
3.
NEVER turn on the pump or energise the device without attaching the recirculation
arm shown in step 4 of the instructions. If you do not fit this arm, you could be at risk
of spraying hot wort into the air causing injury.
4.
Do not run the pump dry for extended periods. This can damage the pump.
5.
NEVER lift the BrewZilla when it is completely full, we strongly urge you to use a hose
to fill your unit. Use the pump or ball valve to transfer your wort. Lifting a heavy /
hot BrewZilla may result in serious injury.
6.
If at any stage the recirculation arm is not fitted and/or needs to be removed always
ensure the ball valve is turned off (see instructions under the heading
7.
NEVER clear a blocked pump by spraying water down the recirculation arm or
directly into the pump inlet. 8. Do not boil dry. Do not turn on the elements
8.
Do not boil dry. Do not energise the device or begin a profile from the RAPT Portal if
there is less than 4 litres of liquid in the boiler. This is the minimum fill level.
9.
Never direct a garden hose or mains water down the pump inlet or recirculation pipe
as you risk rupturing the silicone hosing on the underside of the brewery.
10.
Use only the recommended cleaners and sanitiser products listed in the
recommended accessories section (p.20-22). Using chemicals not tested or
recommended on the BrewZilla can result in permanent damage and void warranty.
If you require further assistance with chemical compatibility please contact
