BrewZilla 100L - Gen 4 Instruction Manual
Page
30
of
48
www.KegLand.com.au
Last Updated 09/02/2024 12:20 PM
account. To re-register your BrewZilla controller do not delete the device from the RAPT
Portal, instead follow the steps below:
1.
On your BrewZilla controller, enter the
Settings Menu
and then navigate to
Clear Registration
and press
Select
to clear the device registration
2.
Open the RAPT Portal (
) and click on the edit button of the BrewZilla
controller you wish to re-register
3.
Go to the
Troubleshooting
tab and select the
Reset Device Authentication
button
4.
When prompted, enter the new Validation Code that is generated on the BrewZilla Controller
and click
Save.
Your BrewZilla should now be registered successfully
The BrewZilla Controller has been sending telemetry but is no longer sending
telemetry
This can occur for a number of reasons:
•
Check that the BrewZilla is still connected to your Wi-Fi network.
•
Check that the BrewZilla is within range of the Wi-Fi router.
•
There may be an interruption to the network or internet.
•
There may be a Wi-Fi connectivity issue caused by unusual network setups or network
security settings.
If you are still experiencing issues, please contact [email protected] for further assistance
Updating Firmware
Your BrewZilla will automatically check for and install firmware updates when powered on and
connected to Wi-Fi.
To check the latest firmware version installed on your device press
Select
and enter the
Settings
menu. Then navigate to
Diagnostics
and the installed firmware version (
ver
) will be displayed.
To manually perform a firmware update press
Select
on the device and enter the
Settings
menu. Then
navigate to the
Check for OTA Update
and press
Select
.
