Kegel IKON Lane Machine, Руководство по эксплуатации

Страница: 62 / 167

49
CHAPTER
6
Adjustments
Conditioning System
Buffer Brush
The buffer brush is made of a long-lasting synthetic bristle,
which under normal circumstances, can be expected to
last approximately 18 months. However, changing this
annually before each league season is recommended to
ensure consistency throughout the year.
To check the buffer brush adjustment, the brush must first
be in the down position. This is done at the
INPUT/OUTPUT
TEST menu. If the brush is not already down in the "zero"
position, press BRUSH LIFT . Press TEST BUTTON to activate this
output. This will lower the buffer brush into the operating
position.
With the brush down and the machine standing in the
transport position, hold a level or straight edge across the
front drive wheels and rear drive wheels (shown above).
The buffer brush material should extend approximately
3/32" to 3/16" (2.38 mm to 4.76 mm) beyond the straight
edge for proper adjustment. The buffer brush is factory
adjusted prior to being shipped at approximately 1/8 " (3.2 mm).
If an adjustment is needed, loosen the bolts located on
the rear panel as shown in the pic. This will loosen the LDS
shaft/wheels so that you can raise the shaft for MORE
crush, or lower the LDS shaft for LESS crush. This is done
easiest with the machine in the transport position.
NOTE:
When cleaning the buffing brush, NEVER use any type of cleaner on the brush.
Use of cleaners will decrease the brush’s ability to hold conditioner and greatly affect
the lengthwise taper of the conditioner pattern. All that you need to clean the buffer
brush is a clean, soft, dry rag.
3/32 – 3/16
Adjusting Bolts
Front drive wheel
LDS wheel
3/32” – 3/16”