KEF PSD 5, Инструкция по эксплуатации

Страница: 11 / 29

10
4 VFCB-complete exhaust unit
4.1 Assembling and mounting of VFCB
– complete exhaust unit
The following description of assembling and mounting of VFCB-exhaust unit is valid both if
it is a VFCB-220 or if it is a VFCB-121. The mounting order is exactly the same for both
models.
The guard (A) (see
fig.: 5.1 ) is first mounted on the back of the machine and there after as
shown on the VFCB-motor. Dismount the blindstopper at the back of the machine and
mount the connector (B). Dismount the switch on the machine without dismounting the
wires. Lead the wire (C) through the connector (B) and mount the protection hose (D) on
the connector (B). Mount the wires from the VFCB-exhaust unit on the switch (see wiring
diagram). Mount the switch again. Dismount the blind guards on the cover or the belt arm
and instead mount the guard (E) with exhaust connecting piece, also remember to mount
the cork washer (F). Finally adjust the suction hoses (G) and mount the clip washers (H).
VFCB-exhaust unit must before use be mounted with suction hoses on the suction
connecting piece (I), which then must be connected with central exhaust unit. If the central
exhaust unit has no cyclone, the exhaustion from the VFCB-exhaust unit must be
connected to a cyclone, which then again is connected to the central exhaustion. If there is
no central exhaustion, dust bags (J) can be mounted on the exhaust connecting unit (I).
In case the VFCB-exhaust unit is mounted on the PSD 5 double grinder, the casted pipe
bendings (K) can be used to mount the VFCB-exhaust unit on the grinding machine by what
the guard (A) and the suction hoses (G) with accessories can be left out.
Fig.: 4.1
4.2 Maintenance of VFCB-exhaust unit
Nothing on a VFCB-exhaust unit requires maintenance except that it is necessary to make
sure that the suction hoses are intact and the suction channels are clear.