SteelTrak 165 and 210 Installation
Manual
The world’s finest cutting machines
www.keencut.com
+44 (0) 1536 263158
+1 (716) 748 6203
[email protected] (UK HQ)
[email protected] (US sales)
Scan the QR code or
click here to view this document online >
Page 12 of 29
Align the hole at the bottom of the strut with the highlighted hole
in the squaring arm. Insert the countersunk screw into to the
squaring arm, use a 5mm Allen (Hex) key to tighten the screw
firmly.
IMPORTANT: Ensure that this is tightened as much as you
possibly can using the short end of the Allen (Hex) key (as shown).
If this screw is not tightened enough, the squaring system will not
work.
Do this firmly
Check that these three screws have definitely been tightened
fully.
Note: lifting the long end of the squaring arm could release some
pressure on the screws and allow for further tightening
DO NOT PROCEED IF YOU HAVE NOT FULLY TIGHTENED THE 3 SCREWS HIGHLIGHTED ABOVE
Insert the countersunk screw into to the squaring arm on the left
side of the slideway, use a 5mm Allen (Hex) key to tighten the
screw firmly into the spine.
IMPORTANT: Ensure that this is tightened as much as you
possibly can using the short end of the Allen (Hex) key (as shown).
If this screw is not tightened enough, the squaring system will not
work.
Do this firmly
