Excalibur 3S user guide
The world’s finest cutting machines
www.keencut.com
+44 (0) 1536 263158
+1 (716) 748 6203
[email protected] (UK HQ)
[email protected] (US sales)
Scan the QR code or
click here to view this document online >
Page 27 of 27
Place a piece of firm board up to 6mm (1/4”) thick on the
machine to bridge the gap running down the back of the main
body, this needs to be the full height of the clamp.
Place a piece of card or foam board 3-6mm (1/8”-1/4”) thick
under the full length of the flexible part of the sightline strip, not
under the aluminium clamp itself. Depress the clamp handle so
that the sightline strip is pressed flat across the surface of the
board.
Keep fingers clear and using a block or tool hold down the top
left corner of the strip to start the cut. With the turret ratchet
disengaged (see
) press the blade
lightly on to the surface of the sightline strip and score along the
full length. Repeat and trim the sightline strip in 2 or 3 cuts.
NOTE: If a board is not available to go the full length of the clamp use two or more pieces or trim the strip in stages.
