Evolution3 SmartFold User Guide
The world’s finest cutting machines
www.keencut.com
+44 (0) 1536 263158
+1 (716) 748 6203
[email protected] (UK HQ)
[email protected] (US sales)
Scan the QR code or
click here to view this document online >
Page 25 of 48
Check that the material is not being pushed into the cutting
groove as the blade is cutting. If so, the material is likely to be
suited to being cut with the rotary blade of the Fabric tool
head where the underside of the material is supported on a
plastic cutting strip. As a short term measure, it is possible to use
the Graphik blade on the plastic cutting strip but too much use
will quickly wear out the strip. Refer to the Fabric tool head for
instruction to engage the cutting strip.
Scoring Acrylic and other plastics can be achieved by setting the
blade at minimum depth and running the blade backwards across
the surface whilst applying firm downward pressure on the blade
holder.
Remove the material from the cutter for snapping by hand, some
plastics may benefit from being scored multiple times.
When cutting a small piece of board place it at one end of the
cutter and place a scrap piece at the other end to keep the cutter
bar parallel to the base.
