PL010
Issue 01
PLEASE BE ADVISED:
Before assembling the Panel Lifter for the first time, it is highly recommended
that Installers familiarise themselves with the component parts and carry out a test assembly and
disassembly in a safe area away from the point of final installation. All component parts detailed in the
operating instructions must be used in the assembly of the system. Should a piece be missing or
appear defective do not continue to assemble and contact Easi-Dec Immediately.
Step1 Step 2
Before adjusting for height, unlock the Clutch and release the
spare rope. This will allow the rope to feed through the clutch as
you extend the ladder.
Position the ladder with the stand-off
above
and central to the
window in order to allow sufficient room for the screen. Where
the soffit board is immediately above the window the stand-off
may be rested against the facia board or onto the roof.
Remember to follow the 4:1 ladder rule for the correct angle
against the wall.
Step 3 Step 4
When the ladder is correctly positioned, the bottom stabilisers
should be positioned. Loosen the black knob and slide the
stabiliser up the ladder stile.
Release the locking pin and rotate the stabiliser towards the
ground, the locking pin will engage when it is set at the correct
angle.
Step 5 Step 6
FIG1. Positioning
Allow the stabiliser to slide down the ladder stile until the foot is
in contact with the ground. Tighten the knob firmly
by hand
, it
does not have to be over tightened.
Attach the clip to the screen. The ‘pin’ should be positioned
centrally about one third down from the top of the screen. FIG 1.
Push the pin through the hole until the plate is flat against the
screen. Slide the top section of the clip down, in and up to lock
the clip in place.
