KEDDY K800 Series, Руководство по установке

Страница: 6 / 16

EXAMPLE A
Rear connection directly into a chimneybreast or
a masonry chimney, e.g. a Heda Chimney.
Mark the centre for the hole in the wall for the flue.
Check that the height agrees with the stove's connec -
tion height. Make a hole with a diameter of approx.
180 mm using a drill and a chisel.
Install a pre-bushing of approx. Ø180 (not included)
using heat-resistant mortar. The connecting pipe
(not included) is measured and cut, so the end of the
pipe ends at the level of the chimney's flue after it is
installed.
When the stove is installed, connect the pipe to the
stove's connection sleeve using a sealant and tightly
caulk with oakum between the flue and the pre-bush -
ing .
NOTE! Bricking the pipe into the chimney is
not allowed.
EXAMPLE B
Rear connection through a flammable wall
The connection is made in the same way as in ex -
ample A, with the exception that the connecting pipe
passes through a flammable wall.
The flammable wall therefore, must be furnished with
a shaft with fire retardant lining (Masterboard, Minerit
or equivalent) and be insulated with at least 100-mm-
thick fireproof insulation around the connection pipe.
Thus, there must not be any flammable material closer
than 100 mm from the flue.
When the outer diameter of the flue is Ø153 mm, the
shaft must be at least 353 mm x 353 mm.
3. UNPACKING / DISMANTLING
The K800, broadly speaking, is supplied completely
assembled, regardless of the model (815, 825 or 835).
In the vast majority of cases, the parts of the stove
models that can be assembled/disassembled are
treated in the same way so, for this reason, we have
chosen to use model 815 as an illustration, i.e. the
cast iron model, as it is applicable to all models.
The stove can be moved in as delivered
but you
should, however, take care with the top stone on mod -
els 825 and 835, as it sits loosely.
If you remove the assembly box prior to carrying it in,
you should also remove the hearth plates as they are
secured for transport using the box.
In connection with the above, or if you want to reduce
the weight of the stove before moving it in, we de -
scribe how you can in a few simple steps remove the
parts involved.
- 6 -
CHIMNEY
CHIMNEY
CUT
OFF
CUT
OFF
BUSHING
BUSHING
CONNECTING PIPE
CONCRETE WALL
FIREPROOF INSULATION 100 MM
INSULATION
SHAFT FROM FIRE-
RETARDENT LINING
WALL