Kebby Power Crimp, Руководство по установке и эксплуатации

Страница: 16 / 20

14 KEBBY INDUSTRIES
CAP REMOVAL SETUP AND OPERATION
NOTE: Cap will be destroyed during removal procedure. In order to use your new
Kebby Power Crimp correctly for cap removal, use the following steps:
STEP 1: Set the air pressure to zero psi. Turn the regulator adjustment knob (Figure 1-5)
counter clockwise to decrease the air pressure to zero psi.
NOTE: The knob is a push to lock, pull to unlock knob. If the knob will
not turn, it may be in the locked position. To unlock the knob,
pull up on the knob and push down on the knob to lock.
STEP 2: Insert appropriate Power Head (sold separately) for de-capping into the Power
Crimp assembly.
NOTE: Caps with plastic tops cannot be de-capped with plastic in
place. It must be removed before de-capping can take place.
STEP 3: Insert the bottle and cap assembly into the
Kebby Power Head De-capper with the pressure
set to 30 psi and actuate the Power Crimp. Wait
approximately 1 to 2 seconds before releasing
the Power Crimp.
If the cap did not come off, increase Crimp
pressure 3 to 5 psi and repeat this step until the
bottle is de-capped. Do not use more Crimp
pressure than necessary.
NOTE: START CRIMP PRESSURE AT 30 PSI.
INCREASE THE CRIMP PRESSURE
IN SMALL INCREMENTS UNTIL THE
CAP IS FULLY REMOVED.
SETUP AND OPERATION
KEEP HANDS
CLEAR OF MOVING
PARTS.
WARNING