Kebby Power Crimp, Руководство по установке и эксплуатации

Страница: 13 / 20

STEP 7: Install the hose fitting onto the back of the verification gauge adapter.
Place a 1 /2” open-end wrench on square block of verification gauge adapter.
Hold the 1/2” wrench stationary and tighten the hose fitting.
NOTE: Do not over tighten the fitting. Minimum pressure is needed
to secure the fitting.
STEP 8: Connect the Power Crimp Hose fitting to the quick
disconnect of the Foot Pedal Assembly.
STEP 9: Connect the Supply Hose to the quick disconnect
fitting on the Foot Pedal Assembly.
STEP 10: Connect the Supply Hose Assembly to the
Gauge/Regulator Assembly.
STEP 11: Attach main air supply (less than 36% relative
humidity @ 60 degrees F) to the Gauge/Regulator.
KEBBY INDUSTRIES 11
FIGURE 1-6
ASSEMBLY