4
Mounting and installation instructions
4.1
General instructions
CAUTION
●
Damage to the operating panel when mounting to unsuitable mounting sur-
face!
●
For reasons of stability and also for tightness reasons, the back side of the
device must be fitted to a completely closed bearing surface (door of switch
cabinet).
●
The operating panel and touch screen could be damaged if the mounting
surface is not level (depending on the operating panel version). Therefore
the mounting surface should neither be bent or warped.
●
The mounting surface must have an evenness of 1mm. This evenness must
be given during operations, as well as during mounting and storage.
4.2
Preparation
●
Getting the required materials (e.g. mounting nuts) and tools (e.g. wrench)
ready.
●
Produce mounting holes and openings.
CAUTION
Before installing the operating panel, check the surrounding seal (on the oper-
ating panel back side) for damage. Only with an undamaged caulking strip is the
front-side protection class ensured.
4.3
Space requirement
Please see the device dimensions for the space requirement to the rear (=
installation depth). The following dimensions are recommended for the mount-
ing holes and the opening of the operating panel.
Operating panel
Mounting and installation instructions
© KEBA 2009
Project engineering manual V2.00
21
Содержание Kemro OP 350/C-1100
Страница 4: ......