Keba KeContact P30 x-series, Руководство по настройке

Страница: 66 / 76

P30 x-series Functions
Configuration manual V4.02
28
© KEBA
4.2.3 RFID authorization with OCPP backend connection
If the charging station or a charging network is controlled by an OCPP back-
end, please note the following:
● Teach in cards:
All RFID cards must be "centrally taught in" at the OCPP backend.
● "Authorization" in configuration to "ON":
Each authorization request is relayed to the OCPP backend.
● "Authorization" in configuration to "OFF":
A charging process can only be started without holding up an RFID card
if the predefined token set in the configuration is recognized and ac-
cepted by the OCPP backend.
Information
For information on the functionality and the required settings of the OCPP
backend, refer to the specific manual of the system used.
4.2.4 Start charging procedure with RFID authorization
1) Plug the vehicle into the charging station.
2) Hold the RFID card, which was previously taught in, in front of the RFID
reader.
3) The rising tone sequence and the green flashing LED bar indicate that
the RFID card has been accepted. The charging session is started.
Information
Enable input X1
For special device variants, the enabling of a charging session can also be
controlled via the enable input X1 (for connecting external components
such as a timer, photovoltaic system or home control). If this function has
been activated in the DIP switch settings, enabling a charging session will
additionally require a correct signal on the enable input X1. Further informa-
tion can be found in the "Installation Manual".