KEB 00.F4.010-3009, Инструкция по эксплуатации, Страница: 6 / 12

GB 6
In this operating mode the parameter lists can
- be read from the inverter (Mode: FU_OP) (Upload)
- be written to the inverter (Mode: OP_FU) (Download)
Hold for approx. 5 sec.
➥
changes operating mode
Operation as Memory Operator
Switch off COMBIVERT
wait until the display or LED is off
Wait until display switches
with 9600 Baud with 19200 Baud
or
! also see 3.2 Changing of the Baud Rate!
Insert Operator and switch on the unit
Error Message Meaning
Display with locked Mode FU_OP.
The Mode FU_OP (Upload) can be locked, to make sure that
the data stored in the operator can not be overwritten.
see also section 3.1 Lock of the Mode FU_OP
Frequency inverter or servo controller was not recognized by
the operator. Possible Cause:
- Connection pin broken/missing
- Baud rate of the inverter / Servo-controller not in accordance
with the baud rate of the operator
see 3.2 Change of the baud rate
To avoid problems for further operations, please pay attention to the
following error messages!
! Further error messages see section 4 error messages!
ENTER
F/R
FUNC.
SPEED
+
2.2 Operation as
Memory Operator
According to the baud rate
of the inverter the display
is shown 5 seconds