WARNING
PROPANE GAS MAY EVENTUALLY LOSE ITS
ODOR AND PRECAUTIONS SHOULD BE TAKEN TO
ASSURE THAT IT IS NOT PRESENT EVEN THOUGH
YOU DO NOT DETECT AN ODOR. IF THERE IS ANY
DOUBT, YOU SHOULD CALL YOUR LOCAL
PROPANE GAS SUPPLIER FOR ASSISTANCE.
CALIBRATION
For Calibration, refer to page 9 – Calibration.
III OPERATING
FILLING
NOTE:
Before filling the fryer make certain the fryer
vessel is sanitized, dry and the drain valve is
completely closed. Refer to item 19 on page 15 for
location of drain valve.
NOTE:
We recommend that solid shortening not be
used in an Incredible Frying Machine Gas Fryer (IFM)
as they are not equipped with a melt cycle. If solid
shortening is used, it should be melted prior to filling
the fryer vessel. Damage done by melting solid
shortening in the fryer vessel will void the warranty.
WARNING
BE SURE THE HEAT TRANSFER TUBES ARE
COMPLETELY COVERED WITH OIL BEFORE
SWITCHING THE FRYER ON. IF OIL LEVEL DROPS
BELOW TOP OF HEAT TRANSFER TUBES,
SEVERE DAMAGE TO FRYER AND INJURY TO
OPERATOR MAY RESULT!
WARNING
WATER (IN ANY FORM) AND HOT OIL DON’T MIX!!!
CAUTION:
Oil expands when heated. The “Fill Level”
line has been provided to ensure optimum cooking
while ensuring the safety of the operator. Do not overfill
the fryer vessel.
Figure 3-1
Fill Level Line
Fill the fryer vessel with oil or MELTED solid shortening
up to the “Fill Level” line.
LIGHTING
WARNING
BEFORE ATTEMPTING TO LIGHT THE FRYER,
MAKE SURE THE GAS CONNECTIONS ARE
SECURE, HAVE BEEN LEAK TESTED, AND THE
FRYER HAS BEEN PROPERLY FILLED WITH
OIL.
1. Turn on main power switch.
2. Set thermostat to desired setting. (Between
325°F/162.8°C) – (335°F/165.3°C)
3. Once main power switch is on and the thermostat
is set, the following occurs:
a. Blower will start and blower indicating light will
come on.
b. After a preset six second delay, the gas valve
will open and the burner indicating light will
come on.
For your safety, the fryer is equipped with a “proof of air
flow” control. If the blower fails, the gas valve will not
open and the burner indicating light will not come on.
c. The spark module will light the burners
automatically.
d. The burner indicating light will be on whenever
the burners are on. The light goes off when the
oil has reached the desired temperature.
NOTE:
The fryer cannot be operated during a power
failure as the electronic ignition system cannot be
operated.
NOTE:
The thermostat can be turned off by turning it
fully counter clockwise until it clicks.
5
