8
ATTENTION /
留意
This product should be installed with a double poles single throw switch (Breaker Switch) with minimum 3 mm contact gap in the fi xed
installation circuit.
Do not use regulator or dimmer switch. (It can damage the Ceiling Fan)
此產品必須在固定安裝電路上裝上觸點間隙為最少
3
毫米的雙極單投開關(斷路開關)。
切勿使用調節器或調光開關。(這會損壞吊扇)
0
5
4
3
2
1
0
5
4
1
Regulator /
調節器
Dimmer Switch /
調光開關
Should there be a regulator or dimmer switch, disconnect it and reconnect the wiring as below.
若有調節器或調光開關,請按照下圖拆除然後重新連接。
Regulator /
調節器
Power Supply /
電源
Power Supply /
電源
Dimmer Switch /
調光開關
Connect Directly /
直接連接
Connect Directly /
直接連接
C)
Installing the canopy /
安裝罩蓋
1
1
Separate the Canopy by loosen the 2 Screws provided.
鬆開
2
枚配備的螺絲分開罩蓋。
Canopy /
罩蓋
Screw /
螺絲
Press /
按
Remove the Screws /
拆開螺絲
Pull /
拉
2
2
Take the Canopy (2 pieces) and clip it until the “click” sound is heard.
拿起罩蓋(
2
片)並夾住直至聽到“滴答"一聲。
ATTENTION /
留意
Make sure both Canopy Rib fi x
into the same level of Canopy Slot
for both side.
確保兩邊的罩蓋凸緣切入對邊相對
的罩蓋凸緣。
Canopy rib /
罩蓋凸緣
Click /
滴答聲
Canopy /
罩蓋