KDK Company, Division of PES
Printed in Thailand
K25DSF2921 NET
T0913-0
K25DSF2NET
(The illustration shows an example of connecting for high
power operation. For low power operation, connect cords
according to the "Wiring Diagram" on page 11.)
Power cord
Terminal
Terminal screw
Spring plate
Copper wire
X Section
It is required to use terminal (Not included)
that complies IEC60998.
Connecting wiring
K28DSM2NET K35DSM2NET K40DSL2NET K40DSH2NET K45DST2NET
(The illustration shows an example of connecting for high power operation. For low power operation, connect cords according
to the "Wiring Diagram" on page 11.)
Installation Instructions
Connecting wiring
1.Insert power cords into the terminal left-side holes as shown below figures.
2.Fasten each screws firmly, and check to pull softly and not to be pulled off or moved.
3.After that, secure power cord with the nylon clamp and its screw so that all cords are not some tension pulled and pulled off.
After connection
Shut the terminal cover and tighten the screws.
At that time, carry out with much care against the
terminal cover biting power cord.
Power
supply
Fan
body
The tip of the power cord which is not used must
be insulated.
Protection tapes or covers for insulation
Terminal: For reference only
(Sold at parts stores.)
K40DTL2BET
K40DTH2BET K45DTT2BET K45DTH2BET
(The illustration shows an example of connecting for high power operation. For low power operation, connect cords according
to the "Wiring Diagram" on page 11.)
Power cord
(2 x 0.75mm
2
)
40
6
It is required to use terminal
(Not included) that complies
IEC60998.
Power cord treatment
X
Nylon clamp
Power cord:
connected by electric technician
(from inside)
Note: Don't loosen
these screws.
Power cord:
connected by
production
Terminal
Power cord
(3 x 0.75mm
2
)
It is required to use terminal
(Not included) that complies
IEC60998.
Power cord treatment
Terminal
X
Nylon
clamp
Power cord:
connected by electric technician
(from inside)
Note: Don't loosen
these screws.
Power cord:
connected by
production
1. Twist the power copper wire
once and plug it into the
terminal socket.
2. The power cord leads must not
become separated or exposed,
and should not come in contact
with other cords.
3. Securely tighten the terminal
screws.
40
6
(1)
Red
White
Black
unit : mm
unit : mm
Head Office : 4017, Takaki-cho, Kasugai, Aichi, Japan