KDK 24CURB, Инструкция по установке и эксплуатации

Страница: 10 / 20

10
再将面罩上另一侧的固定弹簧装入沟槽，
完成对面罩的安装。
Gloves
手套
Fixed spring
固定弹簧
Louver
面罩
Flange
法兰
Ceiling board
天花板嵌板
Keep the gap in the
range of 2
～
3 mm
间隙保持在2～3 mm
范围内
Louver
面罩
Fan body
Fixed spring
固定弹簧
Motion sensor
Motion sensor cord side
机体
动作传感器连线侧
动作传感器
HOW TO INSTALL
安装方法
6 Fix fan body firmly with 4 self-tapping screws
Φ 4.2x20.(Fig.8)
用自攻螺丝φ4.2x20 ( 4颗)将机体牢固的固定 ( 图8)。
自攻螺丝φ4.2x20
(4颗)
Self-tapping screw
Φ
4.2x20 (4 PCS)
■
After finishing installation, please confirm whether
fan body and adaptor assembly are installed firmly.
用步骤②中拆下的螺丝将机体与接头组合牢固的
固定起来(图9)。
7 Fix adaptor assembly and fan body firmly with
hexagon screw removed in step
②
. (Fig.9)
安装完成后，请确认机体与接头是否完全安装牢固。
Fig.8 /
图8
Fig.9 /
图9
Fan body
机体
Hexagon screw
六角螺丝
Screwdriver
螺丝刀
Gloves
手套
Fig.10 /
图10
Fig.11 /
图11
Fig.12 /
图12
8 Connect duct. refer to page 12
2. Connect duct
连接管道。→参考第12页
2. 管道连接
12 IInsert the other spring into the groove as shown
and install the louver to the fan body.
按照图示将动作传感器装入面罩(图12)。
11 Insert the motion sensor on the louver assembly
as shown. (Fig.12)
9 Install ceiling board, keep the gap of flange and
ceiling board in the range of 2~3 mm. (Fig.10)
安装天花板嵌板，使法兰与天花板嵌板的间隙保持
在2～3 mm范围内(图10)。
将面罩组合上的固定弹簧装入沟槽内，
将面罩装在机体上(图11)。
10
Insert the fixed spring of louver assembly into the
groove, install the louver to the fan body. (Fig.11)
1
1
2
Groove
沟槽