7. CONNECTION TO THE MAINS
1
(A)
2.
3
4
5.
8. CONTROLS
1 Refrigeration unit switch:
2. Thermometer:
Thermostat:
a)
3
“
SET or P
”
4
“
UP
”
5
“
DOWN
”
9. CHECKING CORRECT OPERATION
MAKE SURE THAT: 1.
2.
3.
4.
5.
6.
10. INTERNAL CLEANING AND EVAPORATOR CLEANING
(ONCE A WEEK)
(EVERY EVENING)
1.
2.
. 3.
4.
5.
. Ensure that mains voltage and frequency are the same as those stated on the rating plate
attached
to the appliance.
Ensure that the supply socket:
. Ensure
that there is no danger of explosion (AD) in the room. . Make sure the environment is suitable for the
power supply cable provided. The cable of the appliance is H05 VVF, designed for internal use. For
installation in other than internal settings, it will be necessary to replace the cable with the appropriate
type (for example H07 VVF for external settings).
Insert the plug in the socket (do not use three-way
adapters and reduction adapters) (see fig. 5).
The appliance is supplied with adjusting controls located on one side.
to
switch on the refrigeration unit.
to display the temperature in the counter.
to adjust the temperature in the counter.
Press button
once to display the
temperature set-point,which can be changed by pressing button
or button
(see figure 6).
The plug is connected.
The refrigeration unit is switched on and that the green
light is on.
The thermometer shows the desired temperature for the goods to be stored.
The
appliance is not exposed to direct sunlight or high-powered lamps.
The room temperature does not
exceed that in which the appliance is designed to work normally, i.e. +25°C, R.H.60% (climatic class 3).
There are no direct air currents from doors, windows, ventilators or air conditioner pipes, inside the
appliance itself.
(for appliances which are used continuously).
(for daily intermittent
use)
Switch off the appliance.
Should the layer of frost be too thick, and ice drips are noted that could
impair passage of air, complete defrosting should be undertaken. Remove goods and store them in
another suitable appliance running at the same temperature
Remove the plugs from the centre of the
tank.
Allow the evaporators to defrost. Do not use sharp or pointed metal tools to remove the ice.
Clean sides and accessories with a sponge dipped in water or with a little sodium bicarbonate and dry
with care. Pay attention to the cutting edges of the evaporator fins.
a)
b)
c)
is properly earthed;
fulfils the requirements of the
rated current as set out on the rating plate;
complies with the IEC regulations:- thermal-magnetic
switch with In = rated value as stated on the rating plate;- differential with Id sensitivity=30 mA.
I
UK
D
E
F
NL
P
S
DK
FIN
B
GR
CZ
EE
LV
LT
H
M
PL
SK
SLO
7
Operator's guide