7
case, by a suitably qualified technician, so
as to avoid any risk whatsoever.
PROTECTIVE EARTH AND EARTH BON-
DING CONNECTIONS
Connect the appliance to an efficient ground
circuit. Connect the earth conductor to the
terminal with the symbol
located next to
the main terminal board.
Connect the metal structure of the applian-
ce to the equipotential node. Connect the
conductor to the terminal with the symbol
on the outside part of the bottom.
•
This symbol indicates that the appliance
must be included in an equipotential sy-
stem connected in compliance with cur-
rent regulations.
CONNECTION TO THE WATER SUPPLY
The appliance must be connected to a po-
table water supply.
• Install a mechanical filter and a shut-off
valve upstream of the appliance in an ea-
sily accessible point.
•
Make sure the water circuit is free from
ferrous particles before connecting the fil
-
ter and the appliance.
•
Seal any unused connectors with a plug.
•
Once the appliance has been installed,
check for leaks at the connection points.
•
Hot water connection: the water tempera-
ture must not exceed 60°C.
•
The water inlet pressure must be betwe-
en 150 kPa and 300 kPa. Use a pressure
reducer if the inlet pressure is above the
maximum permitted level.
•
The appliance is intended to be perma-
nently connected to the mains water sup-
ply and not via disconnectable fittings.
CONNECTION TO THE WATER DRAIN
The water drainage system must be provi-
ded using materials resistant to temperatu-
res of 100 °C. The bottom of the appliance
must not be subjected to steam produced
by drainage of hot water. Install a sipho-
ned floor drain with grating below the water
drain cock of Boiling pans and in front of
Bratt pans.
12
CONVERSION TO A DIFFERENT
TYPE OF GAS
13 COMMISSIONING
See Chapter " INSTRUCTIONS FOR MAIN-
TENANCE".
INSTRUCTIONS FOR USE
REMINDERS FOR THE USER
The manufacturer will not be liable for
any damage or injury resulting from fai-
lure to observe the following rules.
•
Read this manual carefully. It provides im-
portant information for safe installation,
use and maintenance of the appliance.
•
Keep this manual in a safe place known to
all users so that it can be consulted throu-
ghout the working life of the appliance.
• Installation, conversion to a different type
of gas and appliance maintenance must
be carried out by qualified technicians au
-
thorized by the manufacturer, in complian-
ce with current safety standards and the
instructions given in this manual.
•
For after-sales service, contact technical
assistance centers authorized by the ma-
nufacturer and demand the use of original
spare parts.
•
Have the appliance serviced at least twice
a year. The manufacturer recommends ta-
king out a service contract.
•
The appliance is designed for professional
use and must be operated by trained per-
sonnel.
•
The appliance is to be used for cooking
food as specified in the prescriptions for
use. Any other use is considered to be im-
proper.
•
Do not allow the appliance to operate emp-
ty for prolonged periods. Only pre-heat the
oven just before use.
