User Manual
THYRO
SWITCH
Version 1.0
Page - 1 -
ED
EBD
A
0
08
0
/ 17
07
-1
GB
1 Intended Use
The
THYRO
SWITCH
is a power electronics component for connecting capacitive loads to the power
network. The device is intended exclusively for installation in switchgear and controlgear. Both non-reactor- and
reactor-protected (up to 14%) compensation stages can be switched. First and foremost, symmetrical three-phase
current compensation is intended as the application, but it is also possible to switch two separate alternating
current compensation stages simultaneously.
Technical Data
Eingang:
- Control input
- Fuse protection
10-30V DC or 180-260V AC with 50/60Hz
max. 6A
Supply circuit:
- Auxiliary voltage
- Fuse protection
115V AC or 230V AC 50/60Hz
max. 6A
Load circuit:
- Supply voltage U
N
- Load current
- Power dissipation
400/500V 50Hz/60Hz
max. 115A (500V => 70A)
approximately 2W per A
Application area:
Creepage distance from control input to main circuit:
- Rated voltage
- Harmonic voltage
>10,5mm for SELV-voltage circuits
UN±10%
DIN EN 61000-2-4 class 3; THD max. 10%
Switch-on delay:
Switch-off time >5s
Control input: - DC: 0 … max. 20ms
- AC: 10 … max. 30ms
Re-make tome:
- Cyclic operation
Control input: - DC: 0 … max. 33ms
- AC: 10 … max. 43ms
Electrical safety:
Standards and amendments
- Class of protection
- Distance
- Degree of protection
I
EN61010:2001 pollution degree II CAT III
IP10
Environmental conditions:
- Standards and amendments
- Operating temperature
- Humidity; non-condensing
- Storage temperature
DIN EN 60721-3-3/A2
(3K5+3Z11)
EC 721-3-3 (3K5+3Z11)
-5°C... +55°C
5%...95%
-25°C... +70°C
Mounting:
- Mountin position
- Cooling distances
Vertical or horizontal
min. 50mm to the ventilator and
min.150mm to gate cooler
Housing:
220 x 105 x 188mm (H x W x D)
Weight:
approximately 2900g
