KBL megaSun 3000 Hybrid Thunder, Руководство пользователя

Страница: 44 / 52

M a n u a l e o p e r a t i v o | megaSun space 3000 & hurricane & Thunder Hybrid
44
System messages
ERROR MESSAGES
After the error has been eliminated, all error messages must be acknowledged by pressing START on the interior
display.
No. Status message Description Remedy
01 Excess temperature bimetal Bimetal switch triggers.
Check the air-intake/air-discharge system. Let the
device cool down.
02 Maximum tanning time!
Enabling signal from coin-box system
comes in longer than the time value
approved under “Maximum tanning time”
(voltage remains connected)
Disconnect from the coin-box system.
03
Excess temperature exhaust
fan!
Bimetal switch in the fan triggers.
Make sure the fan runs freely. Check the air-intake/air-
discharge system. Let the device cool down.
12
KBL7 Hardware error
Input-Controller
Mainboard defective. Contact your Customer Service.
13
Maximum write cycle flash
memory reached Maximum write cycle flash memory
reached.
Contact your Customer Service.
14
Error! SD card read error
(CRC fault)
Update via SD card failed (CRC fault). SD card check / replace.
15
Error! no access to the SD
card
Update via SD card failed (access error). SD card check / replace
17
Parameter storage not
found, please connect and
restart
Parameter storage not found, please con-
nect and restart. Check connector parameter storage. If necessary
replace parameter storage.
18
Parameter storage no valid
serial number
Parameter storage no valid serial number. Contact your Customer Service.
19
CAN-BUS: Interior display
V1 is incompatible
CAN-BUS operators incompatible. Use CAN-BUS operaters V2.
20
CAN-BUS: preSelection dis-
play V1 is incompatible
21
CAN-BUS: audio module full
V1 is incompatible
22
CAN-BUS: RGB module V1
ist incompatible
23
Parameter storage write
error
Parameter storage write error.
Check connector parameter storage. If necessary
replace parameter storage.
24 Parameter storage read error Parameter storage read error.
Check connector parameter storage. If necessary
replace parameter storage.
25
Frequency detection: detec-
tion failed!
Frequency detection failed.
Restart the controller. Contact your Customer Service
after the third unsuccessful restart.
26
Frequency detection: power
supply connection faulty
(connector X6/E6)!
Frequency detection failed. No mains
voltage.
Check mainboard connector X6/E6.