Kayden CLASSIC 800 Series, Руководство по эксплуатации продукта

Страница: 38 / 77

ka yd en . c o m
30
Setup & Opera tion
CLASSIC 800 Product Manual
Thermal Signal 1 00% 0
Relay 1
Relay 2
Fault
Set Point 1
Set Point 2 Run Mode
Bypass
RUN
SET
1 2
Thermal Signal
1 00%
0
CLASSIC ™
LED-0 Pointer LED-1 00 Pointer
Scaled Bar Graph View
Baseline Bar Graph View
Thermal Signal 1 00% 0
Relay 1
Relay 2
Fault
Set Point 1
Set Point 2
Run Mode
Bypass
RUN
SET
1 2
CLASSIC ™
8. View or Adjust the 0% & 1 00% Thermal Signal Scaled Bar Graph View
There are two v iews of the Signal Data av ailable for display on the
Thermal Signal Bar Graph
.
1 .
The
Baseline Bar Graph View
shows the maximum possible span/complete thermal range that the
CLASSIC 800 is capable of measuring. Hold Left Arrow in Run Mode with the zero (0%) and 1 00%
LEDs illuminated, the switch is set for the widest range possible.
Note:
The
Baseline Bar Graph View
can only be displayed by pressing and holding the
Left Arrow
while in Run Mode .
2. The Scaled Bar Graph View focuses only on the portion of the total thermal range required for
each application (oil, water, gases). Once the 0% Thermal Signal and 1 00% Thermal Signal settings
are defined, this range (
Scaled Bar Graph View ) will be displayed as 0% to 1 00% on the Thermal
Signal Bar Graph at all times.
To illustrate this principle refer to Figure 22.
The LED-0 pointer is shown set to 50% of Baseline and the LED-1 00 pointer is shown set to 75% of
Baseline. The result is that the Scaled View appears to zoom in on the area of the Baseline data that is
framed by the LED-0 and LED-1 00 Pointers.
The data, indicated by the single illuminated LED, is at 55% of Baseline but on the Scaled View it is shown
as 20%. This is because the data is at only 20% of the v
alues framed by LED-0 and LED-1 00.
Figure 22 – Scaled Bar Graph View vs. Baseline Bar Graph View
Air/Gas
0 - 50%
Oil 40 - 1 00%
Water
50 - 1 00%
25472-1 01 -V1 A-JF00-W0010 Rev 02