High Speed Camera Quick Start Guide
10
NOTE: Powering up the camera will automatically start SDI transmission for local camera
configuration. Detecting the camera using Vision Point application will turn off the SDI output
and the image will be displayed only via Vision Point application interface. For SDI output, the
camera should be powered cycle.
A typical
JetCam
system is connected as described in the figure below.
Komodo Fiber
Frame Grabber
JetCam Camera
Fiber cable
(up to 80 km)
Power
supply
Figure 5 : JetCam Camera system connection diagram
5.5
Vision Point Application installation
1.
Power up the computer.
2.
After OS is up, you will be asked to install a driver for new Multimedia Device.
At this stage, you should cancel the installation.
3.
Run the
Vision Point Application
installation and follow the steps.
NOTE: Under Windows and Linux the compatible drivers for Komodo board will be installed
during installation of Vision Point App software.
For more detailed information please refer to Vision Point Software Installation Guide
documentation.
Installation and Connectivity
