kawneer.com
Laws and building and safety codes gover
ning the design and use of glazed
entrance, window
, and curtain wall pr
oducts vary widely
. Kawneer does not contr
ol
the selection of pr
oduct configurations, operating har
dwar
e, or glazing materials,
and assumes no r
esponsibility ther
efor
.
Kawneer r
eserves the right to change configuration without prior notice when deemed
necessary for pr
oduct impr
ovement.
© Kawneer Company
, Inc., 2011
12
(PART NO. 038-371)
EC 97904-38
NOVEMBER, 2011
PANELINE
®
EXIT DEVICE
SERVICE INSTRUCTIONS
ADJUSTABLE
SETTING BLOCK
(ON "190" DOORS ONLY)
CAP USED WITH
DOUBLE GLAZING
(6) REQ'D. *
DOOR LITE
OPENING
GLASS JACK
(5) REQ'D.
PIVOT STILE
THIS GLASS JACK
ON "190" DOORS ONLY
DOOR LITE
OPENING
RUBBER SETTING
BLOCK (2) REQUIRED
Figure 1
* PARTS INCLUDED IN DOUBLE
GLAZING ACCESSORY PACKAGE
Figure 2
ADJUSTING
SCREWS
MEETING STILES OF A PAIR OF DOORS
Proper clearance for pairs of doors is maintained
by adjusting the weathered astragal. Turn screws
clockwise to allow more clearance and
counterclockwise to allow less clearance.
AFTER INSTALLING DOOR IN NORMAL
MANNER REQUIRED BY METHOD OF PIVOTING:
1. Raise adjustable setting block to maximum
retracted position.
2. Install vertical glass stops first, then horizontals on
one side of door.
3. Install rubber setting blocks (Figure 1).
4. Cut glass 3/8" (9.5) less than door lite opening
width and height for all types of glazing.
5. Install glass, centered between stiles and tight
against bottom rubber setting blocks (Figure 1).
6. Using thumb or tool, rotate glass jacks
counterclockwise to set against glass.
7. Install remaining vertical glass stops first, then
horizontals.
8. Turn the adjustable setting block screw clockwise
and adjust for uniform clearance between top edge
of door and frame.
9. On pairs of doors, adjust astragal (Figure 2).
ADJUSTABLE ASTRAGAL WITH
SEALAIR
®
POLYMERIC FIN
GLAZING INSTRUCTIONS
REMOVE PACKING STRING
FROM PILE AFTER DOOR INSTALLATION.
