Kawamoto Pump RCD-40A0.75, Инструкция по эксплуатации

Страница: 17 / 28

17
１ Introduction
Please check the following items upon receipt of the product.
If there are any problems, contact your dealer.
・ Confirm the upside of the package and open the package carefully. Failure to do
may result in injuries.
・ Do not load handing with the band. There is a possibility that it may be injured
by the band off.
・ This product is skewed center of gravity. Lifted carelessly may occur to be low
back pain.
・ Check the nameplate to ensure that the correct pump has been delivered.
Check the type, output, voltage, frequency, etc. of the delivered pump in reference
with the name plate to verify that the correct product has been delivered.
・ Check that no parts have been damaged during transportation, and that none of
the bolts, nuts, etc., are loose. Tighten any part that is loose.
・ Check that all ordered accessories have been delivered.
２ Specifications
●
●
●
●
●
Always use this pump within the specified product specifications.
Failure to do so could result in electric shocks, fires, water leaks, etc.
Never use this product above the maximum working pressure. There is a risk of
serious accidents.
Caution is required when using this product in a circulatory application, in which
there is no tolerance for rusting, metal corrosion or elution. Carefully select and
review the pump and entire system. The circulating water could become
concentrated and lead to unforeseen damage.
Select a product that matches the application. Using a product for an inappropriate
application will cause faults.
The Danger, Warning and Caution labels indicate information on matters that could
cause bodily harm or property damage. Always observe the indicated information.
Failure to do so could result in device damage, electric shock, fire or injury, etc.
Caution
２．１ All the model community
Coolant，Cutting oil
※The pump cannot be used with fresh water, ocean water, organic solvent,
acid liquid.
Also, using high viscosity fluids will shorten the life of the motor and may cause
the motor to burn out.
Be sure to use the fluids with the viscosity within the limit in the specification list.
Note that the viscosity may greatly increase as the fluid temperature decreases.
Check the viscosity when the temperature of the fluid in use is lowest.
0〜40℃ Contents
Temperature Viscosity Max 75 mm
2
/
s
（RCD-40HA(B)3.0(T4) Type : 60mm
2
/
s
）
Always use the pump indoor in a location free of flammable gas or steam
and at an altitude of 1,000m or less.
0〜40℃ Humidity Under 85％RH
Vertical only
Because the suction port is on the bottom of the pump in the pump section, secure
at least 15 mm between the bottom of the tank and the suction port. Outlet Rp 1 1 /
2
Noise level Under 80dBA
Type Totally enclosed fan- cooled indoor model. Phase 3Phase
200V Type
50Hz：200V
60Hz：200-220-230V
400V Type
50Hz：380-400V
60Hz：400-440-460V
Ambient
temperature
Fluid
Installation
location
Installation requirements
Suction conditions
Motor
Voltage