![background image](http://html2.mh-extra.com/html/kawai/classic-series-cs6/classic-series-cs6_owners-manual_3670872092.webp)
92
Ap
p
e
nd
ix
2. Attaching the back board
d
Allow the assembled pedal board and side panels to stand
upright (vertically) on the floor.
Temporarily fix the back board
d
to the left and right side
panels using the four long black tapping screws
h
, leaving a
tightening allowance of approximately 1-2 mm. Then attach
the bottom of the back board to the pedal board using the
four mid-length black tapping screws
i
.
3. Mounting the main body
a
Ensure that two or more people undertake the
following step of the assembly process.
Lift the main body
a
and carefully place it onto the stand.
Position the main body towards the front of the stand, so that
the screws built into the stand are not visible when viewed
from above.
Gently slide the main body backwards until the base engages
with the fixings and locks into place.
When lifting the main body onto the stand and
sliding it into positing, be careful not to catch/
trap hands and fingers.
Secure the main body to the stand using the four screws (with
the flat washer and spring washer)
g
.
First, loosely attach all four screws (again leaving a 1-2 mm
tightening allowance), adjusting the position of the main body
on the stand.
When all four screws are attached and the main body is
correctly positioned on top of the stand, securely tighten all
screws until the spring washers collapse.
Tighten all of the other temporarily attached
screws securely to ensure that the main body
is firmly attached to the stand. Failing to do so
may result in serious injury.
d
i
i
i
i
h
h
h
h
g
g
g
g
Assembly Instructions