Operating Manual
22
Original Operating Manual
Weekly
Grease:
Sliding pieces (25) by way of the greasing nipples (24).
Supporting rollers (30) on the lower hooks (29) as necessary (31).
Every 200h
Check wear on:
Sliding pieces (25).
Supporting rollers (30).
Prevent entry of dirt, water or moisture into the slewing ring.
Grease:
Slewing ring (3) by way of the greasing nipples (6).
Gearing of the rotary joint (3) by way of the greasing nipples (14).
Every 500h
Check the oil level of the gear box (10).
After 2500h / every 2000h thereafter
Change the gear box oil. (Information KAUP customer service)
Yearly
Check the clearance in the rotary joint (3). (Information KAUP customer service)
As necessary
Renew worn sliders (25) by removing the hooks (29). Remove the complete rotating
clamp in the reverse order to that described in section 4.1. Replace the sliders (25).
During installation pay close attention that the sliders (25) are seated correctly. Then
fit the complete rotating clamp as described in section 4.1.
Replace defective supporting rollers (30) in the hooks (29) by removing the screws
(28). Using suitable hoisting gear tilt the complete rotating clamp forwards away from
the fork carriage on the lift truck. Remove the bolts (31) in the hooks (29), remove the
defective supporting rollers (30) and replace them with new ones. Remount the
complete rotating clamp in the reverse order.
