5.2.-
Function 2 (setup battery discharge current):
Press
key and
key decrease and increase current value, press and
hold can
change value step quickly.
5.3.-
Function 3 (save and exit):
After setup finish, press and
key change the display show "
ES-y
", press "
OK
" key,
means save change and exit setup mode. if you don't
want save changes, please press and
hold "
OK
" key for exit without save.
5.4.-
Function 4 (automatic voltage recognition):
Notes:
This function default is off, battery voltage is 12V or 16V, and you can open this function.
Press
or
key change the display show "
AU-y
", save and exit.
In automatic voltage recognition mode:
5.4.1- If connected battery voltage is 12V, when tester power on, BUZZER will has 1 long
tweet and 1 short tweet;
5.4.2- If connect to battery voltage is 16V, when p
roduct on BUZZER 1 long tweet and 2 short tweet.
Notes:
Automatic voltage recognition only work when tester power on, change the battery need
power off, so suit in the 2-Wire connection mode.
5.5.-
Function 5 (quickly test setup):
Notes:
This function default is off, display show "
F-00
", means not use quickly test function.
Setup value is "
F-01
" to "
F-10
", mean discharge time is “1minute” to “10minute”,
press
or
key set quickly test time, after setup save and exit. In quickly test, quick test time is the
configure time.
5.6.-
Function 6 (constant resistance mode)
Notes:
This function default is off, tester automatic set PWM, to make sure discharge amp equal
to setup value.
Press
key or
key, display show "
Cr-y
", after setup save and exit. The discharge ampere
will determine by the battery voltage and the exter nal discharge resistor, more calculation method
please refer to
supplementary explanation
.
6.-
Finish configure, press "
OK
" key, LED "RUN" is on, mean the tester start battery discharging,
current can arrive to configuration value in few seconds.
Now press
can switch to show different parameters in main dis play. If you want automatic
display, long press
key, the BUZZER tweet means tester in automatic display mode, will
show each battery parameter in 3 seconds interval
Notes:
AH and discharging time is accumulated value, digital display "
.
" flashing, time display "
:
"
