W H E E L B L A N C E R
- 16 -
OPT > key.
Display: [] [180] Display 180° means that the rim and the tire should rotate 180°
each other. Make a mark on the same position
of the taper plate and the rim hole, so that the
rim can be installed back to the same position.
Use the tire remover to rotate the tire 180° on
the rim and reinstall the tire back to the rim.
Display: [82] [35] Left display - shows the percentage of unbalance value that
can be reduced by the current wheel position (%
symbol is shown as).
Middle display - current unbalance value, which can be reduced by rotating the
tire around the rim.
An imbalance value of 35g in the example is reduced by 82%, leaving only
about 6g unbalance after running the program.
[82] [35] A mark is made at the top of the tire (12 o 'clock position) when the
small light in the middle of the unbalance
indicator lights on both sides of the tire is
turned on at the same time.
[82] [35] When the tire is rotated again until the small lights on both sides of the
unbalance indicator light are on at the same time, make a mark at the top
of the rim (12 o 'clock). Remove the wheel and use a tire splitter to
overlap the tire with the rim mark.
