Kathrein UFD 540, Руководство по эксплуатации

Страница: 10 / 80

Command of Remote Control
10
Command of Remote Control
The remote control features 2 command sets, making it possible to
operate 2 receivers independently of each other in one room (not in
conjunction with a twin receiver).
Note
For this purpose, program one receiver on the command set 1 and the
second receiver on the command set 2.
Switch on receiver 1 and receiver 2 off with the mains switch
Press and hold the

button.
Enter in "901" with the number buttons.
To adopt the code, press the

button to switch receiver 1 to
standby and then switch off the device with the mains switch.
Put receiver 2 into operation again.
Press and hold the

button.
Enter in "902" with the number buttons.
To adopt the code, press the

button to switch receiver 2 to
standby and then back into operation. Now switch on receiver 1 again.
Press and hold the

button.
Enter in "903" with the number buttons.
When carrying out the first two settings, the remote control must be di-
rected at the respective receiver (when switched on).
By pressing the

button, you can now switch between the two
command sets A and B (toggle function) and alternately operate both
receivers.
Command set 1 is always active as the on-delivery setting.
If you are operating only one receiver and the active command set is
switched over by mistake so that this receiver can no longer be oper-
ated, the remote control can be easily switched back to command set
1. The procedure is already described above.