Kathrein MobiSet 2, Руководство по эксплуатации

Страница: 10 / 68

10
• Circular cutter, Ø 38 mm
• Flat-bladed screwdriver for M5 screws
• Power drill
• Galvanised round head screws, depending on the roof structure (Ø: 5 mm, sheet metal screws
D 7981, depending on the roof structure) or round head screws D 7985 with washers and nuts
• Twist drill, Ø 2.5 or 5.5 mm
• Round fi le and/or emery paper
• Cleaning agent
• Open-ended or ring spanners 10 and 11 mm across fl ats
• Knife
•
Cross-head screwdriver for M3 and M5 screws
• Torque wrench capacity 6 to 11 Nm
• Allen wrench (5 mm)
• Two wooden beams for supporting the turntable
REQUIRED TOOLS AND EQUIPMENT
INSTALLATION AND CONNECTION
The CAP 610 must not be carried on the planar antenna, since this can cause the antenna to distort.
Keep the device in its cardboard box for transport on to the vehicle roof. Only take the turntable out of
its packaging when it is on the vehicle roof. Retain the original packaging, as if it is necessary to send
the unit for repair transport damage cannot be ruled out and the manufacturer accepts no liability for
possible damage.
Loosen the six fastening screws (width A/F: 10 mm). Carefully lift the turntable off the mounting
plate and place it on the two prepared wooden supports. Make sure that the cables are not crushed
where they emerge from the underside of the turntable.
UNPACKING AND PREPARATION
Essentially, the cable lengths of the MobiSet 2 CAP 610 components allow you a free choice of installation
location on your caravan or motor home.
However, you should take note of the following points:
• Before installation, you should fi nd out whether the operating manual for your vehicle permits the
fi tting of non-vehicle-speci fi c parts or what requirements need to be met in order to do so.
• For direct satellite reception, there should be no obstructions between the antenna and the satellite.
Therefore, make sure that the antenna is not shadowed by roof extensions such as luggage racks,
air conditioning units, solar panels, etc. The problem of shadowing applies also to the selection of
the parking place for your vehicle. For interference-free satellite reception, the antenna needs
a projected free view to the South at an angle of between 15° and 55° (depending on location)
to the horizontal.
SELECTING THE INSTALLATION LOCATION