7
Connecting the glass breaking sensor and putting it into operation
1.
Open the housing by loosening the screw at the bottom.
2.
Insert the supplied battery.
3.
Open the configuration menu of the alarm panel and then the menu
“Sensors”
“Add” and press “Start”.
4.
Press the Learn button of the glass breaking sensor once.
5.
The sensor is listed in the lower menu after a short time and you hear a brief
signal tone from the alarm panel.
6.
Press “Add” to complete the connection process.
7.
Close the housing and fasten the screw.
Range test:
To test the signal strength at the desired installation location, perform a range test.
1.
Open the alarm panel menu “Sensors”
“Range” and press “Start”.
2.
Press the Learn button of the glass breaking sensor.
3.
The sensor and the signal strength should be indicated. The higher the
indicated number the better the reception (1 – 9).
4.
Click “Stop” to end the test.
Please note:
If there is no signal at the installation location or the signal strength is below 4 or
frequently falls below this level (signal fluctuations of 2 to 3 are normal), we
recommend using a repeater to improve the signal.
Dip switch:
The sensitivity of the glass breaking sensor can be adjusted by the two Dip switches:
Sensitivity
Dip switch 1
Dip switch 2
Reach
Maximum
OFF
OFF
8 m
Medium
OFF
ON
5 m
Low
ON
OFF
3 m
Minimum
ON
ON
1.5 m
Test mode:
Press the Learn button to activate the test mode of the FGM 100 for five minutes. If
glass breakage is detected during this time, the red and the green LED will light up.
This allows you to test the function of the glass breaking sensor without triggering an
alarm at the control panel.
