3 / 8
Installation and Safety
•
The equipment described is designed solely for the installation of satellite
receiver systems.
•
Any
other use or failure to comply with these instructions will void the war-
ranty or guarantee.
•
The equipment may only be installed in dry areas i
nd
oors. Do not install on
or against highly combustible materials.
•
The equipment must be provided with an earthing wire (Cu, at
le
ast 4 mm
2
).
•
The safety regulations set out in the current EN 60728-11 and EN 60065
standar
ds
must be complied with.
•
Fixings: Screws, max. Ø: 4 mm
•
Connectors: RF connector 75
Ω
(series F) acco
rdi
ng to EN 61169-24.
•
Unused RF ports must be
te
rminated with 75
Ω
resistors (e.g. EMK 03)
.
Current-carrying device
•
Do not open the unit or tamper with it!
•
When working on the system always unplug the power supply unit from the
wall socket!
•
The device is intended only for wall mounting! Do not install the device lying
fl
at or on its top, or operate it in th
is
position.
•
Ensure adequate clearance! Clearance all round at lea
st
5 cm!
•
Free circulation of air must be possible to discharge the heat emitted by the
u
ni
t. Danger of overheating!
•
Ambient temperatur
e
range -20
to +55°C
Caution:
•
No liquid-
fi
lled items may be placed on top of the power supply unit.
• T
he power supply unit must not be exposed to dripping or splashing w
at
er.
•
The mains plug must be easily accessible and operable.
•
The only reliabl
e
method of disconnecting the unit from the mains is to un-
plug it.
•
An inner cable conduc-
tor diameter greater than
1.2 mm, or the presence
of burrs may damage the
sockets on the unit.
Max. 2 mm
excess
length
Tightening
torque 3.4 Nm
(danger of
overwinding)
Diameter 0.6-1.2
mm free of burrs
