Kathrein 20610100, Руководство пользователя

Страница: 24 / 72

10 / 14
Note: For COFDM modulation the maximum data rate in the output channel is usually lower than the received
data rate. For this reason the channel
fi lter must normally be switched off.
If the channel fi lter is switched on, a display appears next to the parameter indicating the current output data rate. Since the data rate
can vary depending on the channel content, the instantaneous and maximum values are displayed.
Note: Only average values that can vary based on channels are displayed. To ensure error-free functioning and
plan for at least 10 to 15% reserves, i.e. the data rate utilisation should not be above 85 to 90%.
The “Channel fi lter” sub-menu is exited using the “Sub-menu” button .
1.13 Transport stream processor: changing IDs
Note: If the maximum possible number of channels carried over is exceeded, an error message appears.
Main menu
A 1236 MHz TP
27.500 MS/s 3/4 QPSK
Outp. S21 306.00 MHz
8 MHz QAM64 !
“Transport stream processor” sub-menu
*** UFO331TP ***
Filter on 62% / 76%
IDs CI
The setting of the “ID” is performed in the TP (Transport stream processor) sub-menu.
The “TP” transport stream processor is selected using the “<” and “>” buttons, and the sub-menu is called up using the “Sub-menu”
button .
The “IDs” function is called up using the “<” and “>” buttons, and the sub-menu is called up using the “Sub-menu” button .
Here you can edit the operator ID, the transport stream ID and the original network ID as required.
“Transport stream processor” sub-menu
*** UFO331TP ***
Filter on
IDs
CI
“IDs” sub-menu
*** UFO331TP ***
OID orig
TSID orig ----h
ONID orig ----h
1.13.1 Operator ID (OID)
The “OID” CAT operator ID can be set in the IDs sub-menu. To do so, use the “<” or “>” keys to select “orig” next to the OID
parameter and then use the “+” or “-” to set the “edit” value. The OID value now appears in hexadecimal notation. In the “edit”
setting you can modify the value. To do this, select the value using the “>” key. Use the “+” or “-” key to change the current value
in ± 1 increments. Alternatively you can also select numeric setting mode by pressing the
button. In numeric mode each digit
can be modi fi ed by pressing the “+” or “-” keys in ± 1 increments. The values available are “00h” to “FFh”.