KASTOR Karhu PK 007, Инструкция по установке и эксплуатации

Страница: 7 / 33

Lift the water tank lid (remove protective plastic from the lid) and screw the head in so that it
is outside the lid.
Water tank tap (Image 1.1)
•
Choose a side to attach the tap.
•
Place the seal on the threaded part of the tap.
•
Push the tap into the hole in the water tank.
•
Tighten nut on the tap.
•
Place seal on the plug thread.
•
Push the plug into the hole in the water tank.
•
Tighten the nut on the tap.
2.1.4 Water heat-up rate adjustment ES heater
When the switch is moved to the right, the water heat-up rate is at its fastest
2.2. Stones and their arrangement
Use peridotite or dunite or darkish natural stones with diameters of over 10 cm. always wash
the stones before installing them. They must not be stacked too tight or heaped up –
arrange them so that plenty of air can pass between them to warm the upper stones, as
well.
Fill the space intended for stones until it is full, so that
flat stones are placed in an upright
position, (image 2.1) maximum amount of stones, table (1).
By adjusting stone size, amount and adding other types of stone you can balance the steam
consistency to suit the sauna and your preferences. Since these are highly individual, we
cannot give a general rule of thumb – you will find the right mix by trial and error.
For the stove’s proper functioning it is essential that the hot air circulates between the stones
to heat them quickly. If the stones are too small or improperly arranged, you will heat the
sauna instead of the stones!
2.3. Stove base
The stove must be installed horizontally, on a stable and unmoveable non-flammable or
fireproofed base. For this, you may either use Kastor’s separately sold protective stove
base (picture 7)
The front corners of the stove are equipped with adjustment screws, with which it can be
straightened horizontally on an inclined. The adjustable legs are delivered in the
equipment bag in the stove’s fire compartment. Screw them into place and adjust as
needed.
We do not recommend installing the stove directly on a tiled floor, as its moisture sealing, tile
glue etc. may contain components that are not heat resistant.
Fireproofing of the floor on flammable material:
400 mm in front of the stove
On the heater sides 50mm
At the heater back 50mm
(Or, at the sides and back up to a fireproofed wall; picture 2.2.).
NOTE! Always check floor load capacity. Check the heater weight, stones included, from table (2).
2.3.2
.
Installation on tiled and waterproof floor
The Kastor protective stove base is sufficient, a separate fronting plate is not necessary.
(picture 7)
7