KASTOR Karhu PK 007, Инструкция по установке и эксплуатации

Страница: 6 / 33

•
Remove all extra stickers and protective plastic (excluding type/CE mark stickers).
•
Make sure that the grate (chapter 2.8 ) is in place.
•
Install the connecting tube to the flue opening above the heater.
•
Check the sweeping opening and flue opening lids.
2. Installation and preparation for use
2.1. Preparing for use and burn-in
•
Install door handle
•
Place the heater on a non-flammable surface outdoors, without stones.
•
Remove water tank by removing the tap and lifting the tank. WTR and WTL models
(2.1.2)
•
Front tank model FWT, attach tap and cap and fill tank with water (2.1.3).
•
Remove all extra stickers and protective plastic (excluding type/CE mark stickers).
•
Make sure that the grate (chapter 2.8 ) is in place.
•
Install the connecting tube to the flue opening above the heater.
•
Check the sweeping opening and flue opening lids.
•
Burn-in: The purpose of the burn-in is to remove out of doors any flammable protective
coating substances and to harden the stove’s coating. Burn a few full loads of wood in the
fire compartment. Continue the burn-in until there are no more fumes rising from the
stove.
•
Once the stove has cooled down after the burn-in, move it into the sauna.
•
See to it that the sauna is well ventilated during the first couple of heating.
2.1.2 SIDE WATER TANK VO and VV
Empty the water tank before outside temperatures drop below zero; the tank is damaged if
water freezes in it.
Water tank lid
Lift the water tank lid (remove protective plastic from the lid) and screw the head in so that it
is outside the lid.
Water tank lid
In order to avoid damage during transport, the heater water tank tap has been stored inside.
A tap, two seals and a nut are included. Water tap is attached on the sauna side. It is
attached as follows: (Image 1)
•
Water tank is lifted.
•
First seal is placed on the tap thread.
•
Tap is pushed into the hole on the heater cover.
•
The other seal is placed on the tap thread inside the cover.
•
Water tank is lifted into position, and the hole is placed on the threaded part of the tap.
•
Place the edge of the water tank on the side bracket.
•
Nut for the threaded part of the tap, tightened using a suitable wrench inside the water
tank.
2.1.3 FRONT WATER TANK ES
Empty the water tank before outside temperatures drop below zero; the tank is damaged if
water freezes in it.
Water tank lid
6