30
Use a 45° bent pipe for the connection from the top of the stove, which can be turned to align
with the chimney. Suitable 45° bent pipes are available at the hardware store. Extend the
bent pipe with an extension piece, if
necessary. Install the stove’s own connection pipe in
the flue opening on top of the stove according to stove model instructions. The bent pipe
is then attached to the stove’s own connection pipe. Saw the bent pipe and any extension
pipe down to a suitable size where necessary. Make sure the pipe extends sufficiently into
the chimney (but not so far that it blocks up the chimney).
Seal the empty space between connection pipe and chimney with flexible, fireproof material
such as stone wool. The lead-through is then tidied up with a Kastor covering plate, which
is available at your hardware store. The covering plate is attached to the wall with metal
bolts or fireproof paste. See picture 2.5.2.
2.7.4. Connecting to a Helo chimney.
The Helo stove can be connected from the top to a factory built Helo chimney. (check 2.4).
Make sure to choose the correct chimney type with regard to your stove model, chimney
height, temperature class T 600, exterior circumstances etc. For best results we
recommend that you install a chimney valve.
•
Install the heater's own connecting pipe to the upper flue opening on top of the heater.
•
Install a no insulated connection pipe and any necessary extension piping on top of the
stove’s own connecting pipe. Where necessary, saw the connection pipe and the
extension pipe down to suitable size.
•
Install a no insulated connection pipe and any necessary extension piping on top of the
connecting pipe.Where necessary saw the connection pipe and the extension pipe down
to suitable size.
•
The chimney valve goes between the insulated and no insulated sections or into the first
insulated pipe section.
•
Continue from the chimney valve with an insulated pipe. The insulated pipe section must
start at least 400 mm beneath the ceiling. Follow the installation and usage instructions
for Kastor chimneys.
Remember to keep all safety distances to flammable and non-flammable materials named
above.
Helo Oy does not guarantee the suitability and functioning of other manufacturers’
factory-built chimneys with Helo stoves. Helo Oy does not accept liability for the quality of
other manufacturers’ factory-built chimneys. The chimney must fulfil the requirements of
temperature class T 600.
2.7.5 The caultron door and changing the opening direction
The opening direction is changed by turning the door upside down.
Changing the door's left/right-handedness:
•
Open the door and push the hinge pin out of the lower hole.
•
Pull the pin downwards out of the upper hole to release the door. Remember the
washers.
•
Turn the door into the desired position.
•
Slip the hinge pin first into the sleeve's upper hole and the washers on top of the sleeve
onto the pin. (The risers on the pin must be at the lower end.)
•
Slip the door's upper hole onto the hinge pin above the sleeve.
•
Finally, guide the hinge pin into the lower holes of the sleeve and the door.
2.8. Grate
There is a grate in the heater's stove. Place it on brackets on the bottom of the stove
.
