KASTOR FERO, Инструкция по установке и эксплуатации

Страница: 36 / 66

36
Make sure to choose the correct chimney type with regard to your stove model, chimney
height, temperature class T 600, exterior circumstances etc. For best results we
recommend that you install a chimney valve.

Install the heater's own connecting pipe to the upper flue opening on top of the heater.
(2.4)

Install a no insulated connection pipe and any necessary extension piping on top of the
stove’s own connecting pipe. Where necessary, saw the connection pipe and the
extension pipe down to suitable size.

Continue from the chimney valve with an insulated pipe. The insulated pipe section must
start at least 400 mm beneath the ceiling. Follow the installation and usage instructions
for Kastor chimneys.
Remember to keep all safety distances to flammable and non-flammable materials named
above. Helo Oy does not guarantee the suitability and functioning of other manufacturers’
factory-built chimneys with Kastor stoves. Helo Oy does not accept liability for the quality
of other manufacturers’ factory-built chimneys. The chimney must fulfil the requirements
of temperature class T 600.
2.3.3. Heaters installed through the wall, Fero-JK general
Stoves with extended feed doors must only be installed into walls made of non-
flammable material (brick, concrete etc.). The non-flammable material must be
arranged around the door extension as shown in picture 6 . The height of the sauna cabin
altitude. If there is a flammable floor in the room with the door, the area requiring
protection must extend 100mm beyond both sides of the door and at least 400mm in front
of it. The protective layer should be a metal sheet with a thickness of at least 1mm.
(protective plate on the floor).
The floors of the sauna and the room into which the stove door opens must be on an equal
level. The room with the stove door may also be on a lower level, but never higher than the
sauna's floor!
The stove and its extension must be installed on a sturdy, immovable, fireproof, level
surface. A cast concrete base is the best choice. If the floor of the room with the door
in it is flammable,
there must be a non-flammable protective layer (i.e. cast concrete or
masonry) of at least 60mm beneath the door extension. The fire protection measures on
the door side must also adhere to the instructions in chapter 2.3.
By adding fireproofing the stove and its door extension may also be installed on wooden
floors. Nevertheless, the dividing wall must be non-flammable (brick, concrete or similar).
For the sauna and the extended door, a concrete slab with a thickness of 60mm is usually
acceptable (remember to take care of moisture draining). The fireproofing on the sauna
side floor must extend 50mm in front of the stove, 50mm at its sides and 50mm behind it
or, at the back and sides, up to a fireproofed wall. The fire protection measures on the door
side must also adhere to the instructions in chapter 2.3.
In unclear cases consult the local fire safety officials.
2.3.4. INSTALLATION THROUGH THE WALL AND FITTING THE FRAME , Fero JK
models, also with water tank
See also the instructions in chapter 2.3. concerning flue pipe installation.
Make sure that you have received the frame that belongs to the door extension (behind the
stove, between the packing hoop and the stove).
Installation through the wall:

Make a hole in the wall. Its size should leave about 10-20mm of clear space all around the
door extension.

Remove the stove door by taking the hinge pin off (note the 2 base plates between door
and frame).