INSTALLATION INSTRUCTIONS
© 2019 Kason Industries, Inc. IS-8600EZ-200 Rev 6 03/19
kasonind.com | 1.800.935.2766 | PAGE 1
8600EZ Power Drive
Single Doors and Bi-Parting Doors
Part Number: 8600*
Prefabrication Instructions
1. Begin door prefabrication by following Sections I through V in the 8600EZ SINGLE DOORWARE SYSTEM PREFABRICATION
INSTRUCTIONS (IS-8600EZ-14A), except do not install Door Stop (38) at door open end of header as instructed in Section
III-D. The open end Door Stop will be installed in a later step.
2. Mounting Motor and Idler. Using
Fig. 1
determine where motor and idler are to be mounted and mark their positions. Place
motor mounting bracket on header in marked position,center-punch holes, drill for 3/8” bolts. Carriage bolts inserted from the
back of header with nuts are recommended. Attach motor onto bracket using supplied bolts (40 in. lbs. MAX), washers and fasten
securely. Install sprocket onto shaft. DO NOT HAMMER ON SHAFT! Attach motor bracket(with motor) to header. Place idler
mount on opposite end of header from motor and above rail as shown in
Fig. 1
, center-punch holes, drill for 1/4” bolts and
fasten securely.
3.
Single Door.
Mount door stops (2 required). Using
Fig. 1
determine stop locations and mark positions as shown. S = 2 x door
opening plus 14”. Install with 3/8” fasteners. (Additional stops may be mounted near bottom of door is desired).
7
1/4
9 1/4
RIGHT HAND OPENING DOOR
LEFT HAND OPENING DOOR
RAIL
IDLER
MOUNT
MOTOR
WITH MOUNT
9 1/4
1/4
7
7
7
1 5/8
1 5/8
4 ½
4 ½
"S"
"S"
6-1/2
DOOR OPENING
6 ½
DOOR OPENING
80
37
Fig. 1
This Booklet Includes:
